Configuring a Remote Probe

Please start the remote probe configurator from the Start menu.

·      Local IP-If the machine has more than one IP address please choose one from the list. This will be the IP address that you have to enter in the Admin Control Panel of your main IPCheck installation for this remote probe.

·      Local Port -Please choose the ports you want to use. Using the defaults should be fine in most cases.

·      Probe Password-Make sure to protect your probe using a password. This must be the same password as you are entering in your main IPCheck installation as well as all other probes!

·      Install/Deinstall/Start/Stop-Use these buttons to control the behavior of the service.

·      Restrict Ips: xx

Click OK when you are ready.